• BOTH CABINETS to have triple pane insulated glass doors on 2/3'rds of the available front face surface with 2 drawers drawers on the remaining 1/3 of the available front face
• Doors to swing to 90 degree opening rather and 180 swing
• exterior materials: Genuine Mahogany and & Highly Figured Crotch Mahogany center panels/drawer faces with rosewood trim for accent
• size: 70" tall [+/- 60" cabinet atop a 10" base], 36" wide ; 30" deep or the equivalent volume in any design of mutual agreement
• Temperature controlled with R45 insulation and 200% of recommended BTU output Thermoelectric coolers
• Artisan Controller/Controllers as needed to coordinate AC & RH
•  internal air recirculation fans regulated by independent adjustable electric timer relay
•  all AC & humidifiers concealed within base and not visible from exterior; all devices to be outside of cigar storage space.
• "frame and panel" design with no center stile [vertical divider] between doors/drawers
•  hardware: Solid Brass  hinges; rotary bar locks on doors, "file cabinet grade" drawer glides with positive stops to hold drawer closed, brass pulls and handles
• Cigar cabinet to be lined with floating panels of 1/4" thick solid Spanish cedar
• pullout trays & drawers of Mahogany or Spanish cedar
• Finish: lacquer 'hand rubbed' effect
• Underside Treatment: leg levelers

•  Upper doors to be 2/3'rds of space available on face
•  behind glass doors  is will be three  full width 'canted' display shelving [pullout]
•  each canted display unit to have lift out trays
•  each pullout canted display unit to have shelf on underside for concealed storage
•  below the glass doors will be 2 rows of drawers for 'boxed' storage
• each drawer to have beaded edging to replicate upper door trim
•  Internal liner of solid 1/4" floating panels of Spanish Cedar
•  Spacing of boxed cigar storage shelving as design permits
•  each  drawer to have handle to be selected to mutual agreement [$20/handle estimated]

 

To be in the "general style and manner" as described above for proportions and features and as shown below except:

• Upper doors to be 2/3'rds of space available on face
• Upper doors to have glass center panels
• Upper doors to have 'bead' trim around exterior perimeter of door frame rather than interior as shown below
• Two 'banks/columns of drawers mirroring the door

          

  
 

       

 

[b] Humidor Locker: to be made to be identical to the 'casework' for the display cabinet ['face frame' and crown so as to match the overall appearance

• Upper doors to be 2/3'rds of space available on face
• recessed behind the glass doors are to be individual 'pull out' lockers
• multiple rows and columns to mutually agreed sizes of lockers of equal [or unequal] sizes
 [9] lockers; 3 rows of 3 lockers of decreasing height from bottom to top
• each locker to be made similar to a file cabinet drawer with a 'positive' closure
• each locker to be built with full height side wall to insure air flow design is unaffected by contents of lockers
• a 'floating tray' will be provided in each locker for loose cigars
• each locker door to have beaded edge frame of rosewood
• each locker drawer to have handle to be selected to mutual agreement [$20/handle estimated]
• each locker to be provided with hardware for future 'personal initial's engraving

            Design to be similar to except that

• Drawer handles to be centered
• No locks
• to be made to 'match' display cabinet described above